Dirt is for real racing, asphalt is just for getting there!

 

 

 

 

Home
Announcements
General Information
Directions
Race Procedures
Track Rules
Race Car Classes
Winners
Photos
Points Standings
Links
Sponsors
Race Schedule
Payout Amounts

  

       

 

 

 

This site is best viewed in 1280 x 1024 or higher resolution

 

General Rules for all Classes as Follows:  (Please note any rule change/decision made at the track over-rides
any printed or published rule you will find here).

 

1.    Raceivers will be mandatory for ALL CLASSES starting July 9, 2010.

2.    NO sheetmetal will be pulled by track official. You will be advised of it and it will be up to you if you want to keep racing or go to the PITS.
 

3.    IF you go off the track you will go to the rear of the field.

4.    If you have a Flat Tire you will have (1) minutes to change it after you get to your pit. We will be timing you!

5.    Do not speed through the Pits or the staging area - any car doing this will be dealt with through Disqualification, fines, or suspension.

6.    All cars must have fuel cell.  Cells must have a minimum 1 ¾”
steel tubing rear protector.

7.    All drivers must have approved fire suit, and approved helmet.

8.    With gloves, shoes, and other fire protection highly recommended.

9.    Fire extinguisher must be mounted in the reach of the driver.

10.  Racing seat with approved 5 point or greater restraint system,
and quick release window net required.

11.  Battery shut off with off and on labeled.

12.  At least 3 bars in front of driver in place of windshield, or mesh
wire in place of windshield, visiting cars that run on asphalt will
be allowed lexan windshields.

13.  Hoods and trunks must have positive fasteners, and doors welded shut.

14.  Tow chains on the front and rear.

15.    Jack Stands must be used when working under car.

16.    Exhaust must exit behind driver’s compartment.

17.    Driveshaft must be painted white, no aluminum or carbon fiber
drive shafts.

18.    Driveshaft hoop:  minimum 2’ x 3/16 steel and go completely
around driveshaft.

19.    Weight must be painted white and have car # painted on each piece
of weight.

 

 

                 




Last modified: 06/28/10